Se-Kure Controls,
®
Inc.
3714 Runge Street • Franklin Pk., IL 60131 • 1-(800) 322-2435 • (847) 288-1111 • Fax (847) 288-9999
©2001 Se-Kure Controls,
®
Inc. Rev. 5/4/01 SCI-9610
Operating Instructions:
6. Turn the T6 Alarm Module Key to the “Stand-By” position. This is the position
that you cannot remove the key.
7. Connect an LE sensor to the merchandise that is to be protected, follow the
important cleaning step closely.
VERY IMPORTANT! Clean the area on the product and the bottom of the sensor with Alcohol Prep Pads.
While the alcohol is still wet, Wipe These Surfaces DRY with a clean paper towel. If the paper towel
shows dirt, REPEAT THE CLEANING STEP until the surfaces are Clean & Dry!
8. Remove the backing sheet from an adhesive and apply it to the bottom of the sensor. PRESS it FIRM-
LY into place to form a good bond.
9. Remove the second backing sheet,
and apply the sensor to the merchandise
on the area cleaned for the sensor.
PRESS it FIRMLY into place to form a
good bond.
10. Plug the sensor into one of the (6) sensor ports of the T6 Alarm Module. Continue applying sensors to
merchandise, and plugging them into the Alarm Module, you may use any or all (6) ports to secure items.
11. Turn the key to the LEFT “ON” position. The T6 Alarm Module will now independently scan the (6)
sensor ports for tampering. The unit also continually checks the AC and battery powered condition with a
GREEN light to show it is operating.
Tampering is the removal of Sensors from the Alarm Module, from Merchandise, Inserting Metal Objects
into Open Sensor Ports, or the attempt to short out a Sensor.
12. To Add or Remove Sensors: Insert the key into the lock and turn it to the RIGHT “Stand-By” posi-
tion. While the unit is in the “Stand-By” mode, it will “BEEP” once every (30) seconds to warn employees
to turn the unit back on.
13. To Re-Set the T6 Alarm after an Alarm: Insert the key into the lock and turn it to the RIGHT “Stand-By”
position.
NOTE: During the “Alarm Mode” and after the key has been turned to the “Stand-By” position, the RED
indicator lights will continue to flash, indicating which sensor caused the alarm. Correct the problem/sen-
sor that caused the alarm and turn the key back to the LEFT “ON” position. The T6 will always search
through its ports and check battery condition when turned to the “ON” position.
SK-905
Rectangular
Adhesive Pads
Remove adhesive backing
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern